3
ABOUT THE SWAYCONTROL
The BMPRO SwayControl is a proactive electronic stability control that
automatically asymmetrically stabilises a caravan/trailer in the event of a sway.
It automatically corrects caravan/trailer sway which can be caused by changing
road conditions, driver error, lateral winds or a passing truck, keeping you safe
on the road.
The SwayControl is mounted on the underside of the caravan/trailer chassis,
wires directly to the trailer braking system and continuously monitors the trailer
to detect sway. If sway is detected, the SwayControl automatically activates the
caravan/trailer brakes to bring them and the vehicle under control.
The SwayControl distinguishes between safe maneuvering and dangerous
trailer sway and does not require driver intervention. With independent control
of left and right-hand side trailer brakes, and continual closed loop feedback,
the SwayControl quickly and effectively applies the necessary braking force to
the side of the caravan/trailer where it is needed to correct caravan/trailer sway.
The SwayControl features a "sleep mode" to conserve the battery. After 30
minutes of inactivity the SwayControl will shut itself off. The SwayControl
"wakes up" when it receives a brake controller signal and is immediately ready to
begin monitoring and controlling trailer sway.
When the SwayControl is in "sleep mode", the current draw from the battery is
35mA ±2%.
COMPATIBLE BRAKE CONTROLLERS
The SwayControl may be used with various integrated and aftermarket brake
controllers, including brake controllers from:
9 Ford
9 General Motors
9 Hayes
9 Nissan
9 Redarc
9 Tekonsha
9 Toyota
9 Fiat
9 Chrysler
Brake controllers from other companies not listed in this manual may also work
with the SwayControl.
To Next Page
Loading...
Need help?
General
