BMT 932 - Page 46

OZONE MONITOR BMT 932 Manual, Rev. 02/2021
46
Cmd Meaning PC->932 932->PC
76 Set Auto/Manual
Has the same effect as pressing "ENTER” on the front panel. Changes
Auto/Manual mode and goes through active channels in Manual mode.
The selected channel is returned. Use command *8# bit 7 to find out if
in Auto or Manual mode.
*76# *76#byte
77 Low Alarm EMO-Mask 3
Reads out assignment of Low Alarms to EMO 3 bits 0..5 set show
assignment of Low Alarms on channel 1..6
*77# *77#byte
78 High Alarm EMO-Mask 3
Reads out assignment of High Alarms to EMO 3 bits 0..5 set show
assignment of high Alarms on channel 1..6
*78# *78#byte
83 Set Sniffer Mode
0: off, 1: on
*83#byte *83#
85 Firmware-Version? *85# *85#float
86 Error Status (binary coded, as decribed in table on page 30): *86# *86#word
91 Set Link-Mode Timeout (after switching on always 10 s)
byte: Seconds
*91#byte *91#
95 Set User Baud Rate
0: 2400
1: 4800
2: 9600
3: 19200
4: 38400
*95#byte *95#
98 High Alarm Parameter Channel 1?
float: Limit in present unit
byte1: Enabled 1 = true
byte2: Latching 1= true
*98# *98#float,
byte1,byte2
99 High Alarm Parameter Channel 2?
parameters as above
*99# *99#float,
byte1,byte2
100 High Alarm Parameter Channel 3?
parameters as above
*100# *100#float,
byte1,byte2
101 High Alarm Parameter Channel 4?
parameters as above
*101# *101#float,
byte1,byte2
102 High Alarm Parameter Channel 5?
parameters as above
*102# *102#float,
byte1,byte2
103 High Alarm Parameter Channel 6?
parameters as above
*103# *103#float,
byte1,byte2
104 Low Alarm Parameter Channel 1?
float: Limit in present unit
byte1: Enabled 1 = true
byte2: Latching 1= true
*104# *104#float,
byte1,byte2
105 Low Alarm Parameter Channel 2?
parameters as above
*105# *105#float,
byte1,byte2
106 Low Alarm Parameter Channel 3?
parameters as above
*106# *106#float,
byte1,byte2
107 Low Alarm Parameter Channel 4?
parameters as above
*107# *107#float,
byte1,byte2
108 Low Alarm Parameter Channel 5?
parameters as above
*108# *108#float,
byte1,byte2
109 Low Alarm Parameter Channel 6?
parameters as above
*109# *109#float,
byte1,byte2