Need help?Do you have a question about the BMW B130 and is the answer not in the manual?
Steps for removing, overhauling, and testing the distributor.
Specifications and installation guidelines for spark plugs and ignition coil.
Procedures for removing, installing, and maintaining the alternator.
Instructions for starter motor removal, installation, and specifications.
Dismantling, adjustment, and installation of the carburettor.
Procedures for fuel pump removal, overhaul, and fuel filter replacement.
Procedures for heat exchanger removal, dismantling, and installation.
Instructions for raw water pump removal, overhaul, and installation.
Steps to remove and take apart the flywheel housing.
Instructions for reassembling and fitting the flywheel housing.
Steps to prepare the engine for disassembly and service.
Steps for removing the flywheel from the engine.
Steps to disconnect and take apart the oil cooler.
Instructions for reassembling and fitting the oil cooler unit.
Steps for dismantling and servicing the water circulation pump.
Guidance for installing the water circulation pump.
Steps for removing the cylinder head and initial disassembly tasks.
Procedures for camshaft removal, overhaul, and valve train maintenance.
Guidance for installing the cylinder head and adjusting valve clearances.
Steps to remove the flywheel, chain, and sprockets.
Instructions for overhauling and assembling the timing chain and sprocket system.
Steps to remove and dismantle the oil pump assembly.
Guidance for correctly installing the oil pump assembly.
Steps for removing, dismantling, and servicing pistons and connecting rods.
Guidance for installing connecting rods, bearings, and pistons.
Steps for removing and overhauling the crankshaft and bearings.
Guidance for installing the crankshaft and main bearing caps.
Recommendations for protecting the engine during winter storage.
Steps for engine recommissioning before and after launching.
To Next Page
General
