BMW C650GT - Removing Rear Wheel

Remove front wheel stand.
Slide the brake calipers onto
the brake rotors.
Install screws 2 on left and
right with appropriate torque.
Brake caliper on fork leg
21 lb/ft (28 Nm)
ATTENTION
Contact between the wheel
speed sensor cable and the
brake disc.
Sensor cable wearing through.
Make sure that sensor cable is
routed correctly.
Insert wheel speed sensor in
bore and install screw 1.
Remove adhesive tape from
wheel rim.
Firmly pull the handbrake lever
until the pressure point is per-
ceptible, and repeat this opera-
tion several times.
Mount front wheel cover and
install screws 1 and 2 on right
and left.
Calibrating ASC ( 52).
Removing rear wheel
Make sure ground is level and
firm and place Maxi-Scooter on
its center stand.
CAUTION
Hot exhaust system.
Burn hazard
Do not touch hot exhaust
system.
Remove the screw 1.
8
98
z Maintenance