BMW D7 - Cylinder Head; Valves

C
ylinder head / Injection pipe / Leak-off-line / Water pump / Water hose / Air filter
Assemble Valves, push rods, rocker arms, cylinder head cover.
Install Injection pipe, leak-off-line, water hose, air filter
23
- Press in valve guides from underneath
- Insert valves
- Insert valve springs with cap and washer
- Insert spring plate
- Insert both valve keys, while applying counter
pressure to the valve
- Insert shaft with gear segment and screw in
internal clamping sleeve.
- Slide handle with ring onto the shaft and screw in
external clamping sleeve.
- Insert push rods
- Insert rocker arms and assemble rocker shaft
with bushing and retaining plate (43)
NOTE
Check that the rocker arms are free to move
- Adjust valve clearance
- Fasten cylinder head cover and vent hose clamp
with both nuts
- Fasten injection pipe to the injection pump and to
the injector
- Attach leak-off-line hose to the injector
- Install water pump
- Fasten water hose to the water pump and to the
exhaust manifold
- Attach air filter
-