G
enerator and generating equipment
35
Preparation
- Remove starter motor
- Detach gearbox/clutch cover assembly
- Remove clutch
- Remove flywheel
Rotor Removal
- Extract spring clip A from flywheel magnet by
inserting snip-nosed pliers into cut-outs provided
Generating Equipment Removal
- Disconnect leads from temperature sensor and
remove stator cable plug C from socket on
equipment carrier
- Remove bolts D (13 & 19 mm), noting position
of spacers, washers and injector pipe clip (if
fitted) and remove carrier and equipment
complete from engine.
Stator Removal
- Detach plug E from stator cables with fine
implement, first marking their positions.
- Pull magnet B from flywheel with even
movement, if necessary with suitable puller
To Next Page
