11
Manual Starting
§ Prepare the starting according to the instructions for a cold engine on page 9
§ Insert the crank handle and make sure it is properly engaged
§ Turn the decompression valve twist grip almost 180
o
clockwise
§ Hold the crank handle as shown i.e. with fingers and thumb on the same side of
the handle thus avoiding spraining the hands should the engine rotate backwards
§ Crank the engine as rapidly and vigorously as possible. After four crank handle
revolutions, the decompression valve will close and the engine will fire normally
§ Remove the crank handle and decrease RPM to normal idling
Aloha Owners Association note – owners of some Aloha 27s advise that due to the
close proximity of the bulkhead there may be insufficient clearance to allow insertion of
the crank handle for manual starting
Stopping the engine
§ Set the control in neutral and allow the engine a few minutes idling in order to
even out any thermal stresses
§ Pull the shut-off handle fully until the engine has completely stopped
To Next Page
Loading...
