Install cap 1.
Replacing brake light and
tail light bulbs
If it is not standing firmly,
the motorcycle could topple
in the course of the operations
described below.
Make sure that the motorcycle is
steady on its stand.
Make sure ground is level and
firm and park motorcycle.
Switch off ignition.
Remove screws 1.
Pull off light housing toward
rear.
Press bulb 2 into socket and
turn counterclockwise to re-
move.
Replace defective bulb.
Bulb for taillight/brake
light
P21/5W / 12 V / 5 W / 21 W
Use a clean, dry cloth to hold
new bulb.
Press bulb 2 into fitting and
install turning clockwise.
8
108
z
Maintenance
To Next Page