Low-beam headlight
The low-beam headlight switches
on automatically when you start
the engine.
With the engine switched
off, you can switch on the
lights by switching on the high-
beam headlight with the ignition
switched on or by operating the
headlight flasher.
High-beam headlight
Press the top section of full-
beam headlight switch 1.
High-beam headlight is
switched on.
Move full-beam headlight
switch 1 to the center position.
High-beam headlight is
switched off.
Press the bottom section of
full-beam headlight switch 1.
High-beam headlight is
switched on as long as switch
is pressed (headlight flasher).
Switching on parking
lights
Switch off ignition.
Immediately after switching off
the ignition, press and hold the
left-hand turn indicator but-
ton 1.
Parking light switches on.
Switching off parking
lights
Switch ignition on and then off
again.
Parking light switched off.
Turn indicators
Switching on left-hand
turn indicator
Switch on ignition.
After driving for approx.
ten seconds or after cov-
ering a distance of approx. 650
ft (200 m), the turn indicators are
automatically switched off.
4
47
z
Operation
To Next Page