Brake-pad wear limit,
rear
min 1.0 mm (Friction pad only,
without backing plate. The
chamfer must be clearly vis-
ible.)
If the wear indicating mark is no
longer visible:
WARNING
Brake-pad thickness less
than permissible minimum
Diminished braking effect, dam-
age to the brakes
In order to ensure the depend-
ability of the brake system, do
not permit the brake pads to
wear past the minimum per-
missible thickness.
Have the brake pads replaced
by a specialist workshop,
preferably an authorised
BMW Motorrad dealer.
Checking brake-fluid
level, front brakes
WARNING
Not enough brake fluid in
brake fluid reservoir
Considerably reduced braking
power due to air in the brake
system
Check the brake-fluid level at
regular intervals.
Make sure the ground is level
and firm and hold the motor-
cycle upright.
with centre stand
OE
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Move the handlebars to the
straight-ahead position.
Check the brake fluid level in
front reservoir 1.
NOTICE
Wear of the brake pads causes
the brake fluid level in the reser-
voir to sink.
9
101
z
Maintenance
To Next Page
