Alarm function
with alarm system (DWA)
OE
Alarm triggers
A DWA alarm can be triggered
by:
Motion sensor.
An attempt to use an unauthor-
ised vehicle key to switch on
the ignition.
Disconnection of the anti-theft
alarm (DWA) from the vehicle's
battery (DWA internal battery
in the anti-theft alarm provides
power).
Alarm
The alarm tone continues for
26 seconds. The system is act-
ive again another 12 seconds
later. Press the 1 button on the
remote control to stop an activ-
ated alarm tone at any time. This
function does not change the
status of the anti-theft alarm.
While an alarm is in progress an
alarm tone sounds and the turn
indicators flash. You can program
the type of alarm tone.
Reason for an alarm
Once you have deactivated the
alarm function, the DWA LED
indicates the reason for potential
alarm activation for one minute:
Flashes once: motion sensor:
motorcycle was tilted towards
the front/rear.
Flashes twice: motion sensor:
motorcycle was tilted towards
the side.
3x flashing: The ignition was
switched on with an unauthor-
ised ignition key.
Flashes four times: the alarm
system was disconnected from
the vehicle battery.
Information on alarm
triggering
If an alarm was triggered after
the last activation of the alarm
function, the rider is notified
accordingly by an alarm tone
sounding once when the ignition
is switched on.
5
60
z
Anti-theft alarm
To Next Page
Loading...
Need help?
General
