BMW F800GT - Page 64

Default settings
The anti-theft alarm ships with
the following default settings:
Confirmation alarm tone after
having activated/deactivated
the DWA: no.
Alarm tone: intermittent.
Automatic activation of the
alarm function when switch-
ing off the ignition: no.
Programming anti-theft
alarm
Deactivating alarm function
( 61).
Switch on the ignition.
Press button 1 three times.
Acknowledgement tone sounds
once.
Within ten seconds, switch off
the ignition.
Press button 2 three times.
Acknowledgement tone sounds
once.
Within ten seconds, switch on
the ignition.
Acknowledgement tone sounds
three times.
The programming function is
active.
Programming is a four-step pro-
cess, although no function is al-
located to step 2. The number of
times the anti-theft alarm LED on
the vehicle flashes corresponds
to the active programming step.
An alarm tone sounds by way of
confirmation when button 1 is
pressed, and an acknowledge-
ment tone sounds when button 2
is pressed.
Step 1: Do you want a con-
firmation tone to sound after
activation/deactivation of the
anti-theft alarm?
Yes:
Press button 1.
No:
Press button 2.
Step 2:
No function allocated to this step.
Press button 1 or button 2.
Step 3: Which alarm tone
would you like the alarm to
sound?
Rising and falling:
Press button 1.
Intermittent:
Press button 2.
Step 4: Do you want to have
the alarm function activated
automatically when you switch
off the ignition?
5
62
z Anti-theft alarm