29
Maintenance and care
2
Removing the rear wheel
Do not damage brake lines,
brake disk, brake pads and
wheel when removing.
Do not damage the ABS sensor
cable, the ABS sensor ring and
the ABS sensor.
• Remove the four wheel
studs 3 with taper rings 4
• Remove central screw 7 with
taper ring 6
• Pull the rear wheel off the cen-
tering spigot and set it down
• Remove spacing washer 5
from the wheel centering
spigot
• Carefully roll the rear wheel
out to the rear
Protect the wheel hub contact
face against dust and dirt.
4 53
6
7
20LTbku7.book Seite 29 Montag, 4. Juli 2005 9:27 09
To Next Page
