24
Maintenance and care
2
Installing the front wheel
Make sure that the motorcy-
cle is standing firmly and can-
not topple forward or to either
side.
Do not damage brake lines,
disks and pads when installing.
Keep dirt and moisture away
from the wheel bearings.
Do not damage the ABS sensor
cable, the ABS sensor ring and
the ABS sensor.
Note arrow on tire indicating
correct direction of rotation.
• Roll the front wheel in
between the fork stanchions
• Clean spacing bushing 10
and bearing cap 9 and insert
them
• Clean quick-release axle 8,
grease it and insert it from the
right (raising the wheel slightly
as necessary)
• Hand-tighten axle screw 6
8
9
A
10
6
7
20LTbku7.book Seite 24 Montag, 4. Juli 2005 9:27 09
To Next Page
