41
Maintenance and care
2
Changing bulbs
• Pull off plug housing 3
• Release spring clip 4 from
retainers A at top and bottom
and swing the clip back
• Take out the H7 bulb
•Insert a new H7 bulb
–Tab B must point upward
• Engage spring clips 4 at top
and bottom in retainers A
• Seat plug housing 3 on bulb
connections
•Insert cover2 with wording
TOP facing upward
• Pull clip 1 up until it engages
Make sure that cover 2 is cor-
rectly seated and that it forms a
good seal.
– Low-beam headlight:
H7 12 V 55 W
B
A
4
3
20LTbku7.book Seite 41 Montag, 4. Juli 2005 9:27 09
To Next Page
