34 DISPLAYS
the following minimum speed is exceeded
for the first time:
RDC sensor is not active
min 19 mph (min 30 km/h) (The RDC
sensor transmits its signal to the vehicle
only once the minimum speed has been
exceeded.)
The tire pressures are shown in the
TFT display with temperature com-
pensation and are always based on the
following tire air temperature:
68 °F (20 °C)
If the tire icon appears yellow or red at
the same time, the display is a warning.
The pressure differential is highlighted with
an exclamation mark of the same color.
If the value concerned is borderline in
terms of the permissible tolerance, the
general warning light lights up yellow in ad-
dition.
If the monitored tire pressure is out-
side the permitted tolerance, the gen-
eral warning light will blink in red.
For further information about the
BMW Motorrad tire pressure control (TPC),
see the Technology in detail ( 116)
chapter.
Tire pressure at the limits of the
permissible tolerance
with tire pressure monitor (TPM)
OE
lights up yellow.
is displayed in yellow.
Tire pressure not at setpoint.
Check tire pressure.
Possible cause:
The measured tire pressure is within the
limit range of the permissible tolerance.
Correct the tire pressure.
Before adjusting the tire pressure, check
the information on temperature compen-
sation and tire pressure adjustment in the
"Technology in detail" chapter ( 116).
The target tire pressures can be found in
the following locations:
On the back cover of the operating
instructions
Instrument cluster in the TIRE PRESSURE
view
Tire pressure table
Tire pressure is outside the approved
tolerance range
with tire pressure monitor (TPM)
OE
flashes red.
is displayed in red.
Tire pressure not at setpoint.
Stop immediately! Check tire
pressure.
Tire Press. Monitor. Loss of
pressure. Stop immediately!
Check tire pressure.
WARNING
Tire pressure is outside the approved
tolerance range.
Risk of accident, deterioration in the han-
dling characteristics of the vehicle.
Adjust the driving style.
Possible cause:
The measured tire pressure is outside of the
permissible tolerance.
Check tire for damage and ridability.
If the tire is still ridable:
Correct the tire pressure at the next op-
portunity.
Before adjusting the tire pressure, check
the information on temperature compen-
sation and tire pressure adjustment in the
"Technology in detail" chapter ( 116).
To Next Page
Loading...
