51
Press button 1 of the radio-operated key
once.
If the alarm function is deactivated us-
ing the radio-operated key and the ig-
nition is not then switched on, it will reac-
tivate automatically after approximately 30
seconds if "activation after ignition off" is
programmed.
Turn indicators are illuminated once.
Confirmation tone sounds once (if pro-
grammed).
DWA is switched off.
Adapting DWA
Switching on the ignition ( 44).
Go to the Settings, Vehicle set-
tings menu, then select the Alarm sys-
tem menu item.
The following adjustments are available:
Adapting Warning signal
Switching Tilt sensor on and off
Switching Arming tone on and off
Switching Arm automatically on and
off
Possible settings
Warning signal: Set increasing and de-
creasing or intermittent alarm tone.
Tilt sensor: Activate the tilt sensor to
monitor the tilt of the vehicle. The DWA
anti-theft alarm system responds, for exam-
ple, in the event of attempted wheel theft or
towing.
Deactivate the tilt sensor when trans-
porting the vehicle to avoid triggering
the DWA.
Arming tone: Confirmation alarm tone af-
ter activating/deactivating the DWA in addi-
tion to flashing turn indicators.
Arm automatically: Automatic activation
of the alarm function when the ignition is
turned off.
TIRE PRESSURE CONTROL (TPC)
with tire pressure monitor (TPM)
OE
Switching setpoint pressure warning on or
off
When the minimum tire pressure is
reached, a target pressure warning can be
displayed.
Go to Settings, Vehicle settings,
RDC menu.
Turn Target pressure warn. on or
off.
AUTOMATIC STABILITY CONTROL (ASC)
Switching ASC function off and on
Switching on the ignition ( 44).
Go to the Settings, Assist menu, then
select the ASC menu item.
Deactivate ASC to switch off automatic
stability control ASC until the next time the
ignition is switched on.
lights up.
Activate ASC to switch on automatic sta-
bility control ASC. Alternative method: turn
the ignition off and on again.
no longer lights up, and if self-diagno-
sis has not been completed, it begins
to blink.
More detailed information on the auto-
matic stability control ASC can be found in
the Technology in Detail ( 112)chapter.
To Next Page
Loading...
