BobsCNC E4 - Step 3: Attach Bottom Mount A

Page 4
Specifications
The E4 CNC Router has the following features:
• Rigid laser cut frame.
• Fully supported rail system with SG20U bearings.
• GT2 belt drive on X and Y axis.
• 5/16-18 coupler nut on the Z axis.
• Home switches on all axes.
• MDF T-Slot Spoilboard with T-Nut inserts.
The assembled footprint:
Length: 30" (630 mm)
Width: 37.2" (945 mm)
Height: 18.9" (480 mm)
Assembled Weight:
32 lbs.
Cung Area:
X: 24" (610 mm)
Y: 24" (610 mm)
Z: 3.3" (85 mm)


  your    
      

Routers have a high voltage power supply and use bits that spin at 30,000
rpm with cung edges that are hazardous. The operator must understand
these hazards and is responsible to take appropriate safety precauons be-
fore operang the Router.

