bObsweep Bob PetHair Plus - Syncing bLock Plus

Quick Start
Parts and Accessories
Syncing blOck Plus™
Syncing blOck Plus™
As with Bob’s remote, you will need to sync blOck Plus™ before using it for the rst time.
1. Press the button. Wait for the red light
on the front side of the block Plus™ to start
slowly blinking before proceeding.
3. Hold down the SYNC button while at the
same time ipping Bob’s power switch ON.
2. Press the button. Wait for the red light
on the left side of block Plus™ to start
slowly blinking before proceeding.
Bob will chirp twice to let you
know the sync was successful.
If Bob does not chirp, repeat the
process.
You can sync multiple blOck
accessories with Bob.
Quick Tip:
Parts You’ll Need: block Plus™ AA Batteries x4
(not included)
6665