EasyManua.ls Logo

bObsweep ORB-i - Page 7

bObsweep ORB-i
73 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Power Orb-i OFF and remove him from a
power source when you are not using him
and before conducting maintenance.
Orb-i is not intended for use by persons
(including children) with reduced physical or
mental capabilities, or lack of experience and
knowledge, unless under the close supervision
of a person responsible for their safety.
Leaks from the battery cells can occur under
extreme usage or temperature conditions. If
the liquid gets on the skin, wash quickly with
water. If the liquid gets into the eyes, ush
them immediately with clean water for a
minimum of 10 minutes, and seek medical
attention.
Orb-i is composed of electronic components
that in rare and unintended cases can cause
hazards of heating, re, and other
malfunctions. Furthermore, because Orb-i
is capable of autonomous movement, his use
poses the risk of collision with property, pets,
and persons. Unintended removal of articles
— such as small valuables, jewelry, or hair of
persons or pets lying on the oor — may also
occur.
If Orb-i or his charging station has been
damaged in any way, do not operate them.
Contact our support team for further
assistance.
Do not handle Orb-i or his charging station with
wet hands; use only on dry surfaces.
Do not pull or carry the charging station by the
cord, close a door on the cord, or pull the cord
around sharp edges or corners. Keep the cord
away from heated surfaces. To unplug the
cord, grasp the plug, not the cord.
Important Safety Instructions
Do not expose Orb-i’s SLAM LiDAR to direct sun light
or infrared light.
Do not let Orb-i drop. The impact from a drop can
damage the SLAM LiDAR.
Do not look directly into the rotating transmitting part
(laser) of the SLAM LiDAR.
For your safety, do not insert tools, ngers, or other
items into the rotating part of the SLAM LiDAR.
Do not attempt to open the charging station.
Repairs on the station should only be carried
out by our qualied technicians.
Do not immerse any part of Orb-i into water or
other liquids.
Do not mutilate or incinerate the battery, as it
will explode at high temperatures.
Do not use Orb-i outdoors.
Do not store Orb-i in a car.
Do not expose Orb-i or his charging station
to temperatures higher than 113° F (45° C),
moisture, or humidity.
Do not dispose of your battery in re. Old
batteries should be recycled safely through
your local recycler.
Do not let Orb-i pick up anything that is burning
or smoking, such as cigarettes, matches, or
hot ashes.
Do not use a broken or damaged power inlet/wire
Do not open or handle Orb-i’s charging station when
plugged into the wall. Unplug rst.

Related product manuals