BOCI BLT481 - Table of Contents

BLT481 Product Manual
Table of contents
BLT481 Product Manual ................................................................................. 1
1. Product Description .................................................................................... 1
1.1 Product View .......................................................................................................................................................... 1
1.2 Technical parameters ............................................................................................................................................. 2
1.3 Meaning of LED indicator ....................................................................................................................................... 3
2. Gas port ...................................................................................................... 4
3. Water cooling interface ............................................................................... 5
4. Electrical interface ...................................................................................... 6
4.1 Bus system ............................................................................................................................................................ 7
4.2 Non-bus systems ................................................................................................................................................... 8
5. Cutting head installation .............................................................................. 9
5.1 Preparation before operation ................................................................................................................................. 9
5.2 Specific operation process ................................................................................................................................... 10
5.2.1 Preparation of clean bench ........................................................................................................................ 10
5.2.2 The cutting head is placed in the clean workbench .................................................................................... 10
5.2.3 Clean and wipe the fiber interface of the cutting head ............................................................................... 11
5.2.4 Check the laser fiber end face ................................................................................................................... 11
5.2.5 Tear off the protective film/remove the protective cap ............................................................................... 11
5.2.6 Insert the laser fiber interface into the cutting head ................................................................................... 12
5.2.7 Wrap and seal ............................................................................................................................................ 12
5.2.8 Mount the cutting head on the backplane .................................................................................................. 13
5.2.9 Installing the ceramic body and nozzle ...................................................................................................... 13
BOCI