25
7. The power cable must be screwed to the lug of the lying surface with the strain relief
provided on the cable. Connect the mains plug.
8. After assembly or before putting the bed into operation, move the adjustment range of
the lying surface over the controller to check the optimum positioning of the cables. The
adjustment range must be passable without obstacles.
9. On the domiflex 185, remove the reinforcing metal braces from the packaging and
mount them on the end piece in the mounting device provided for this purpose, and
tighten them with the screws supplied.
The domiflex is now ready for operation.
To Next Page
Loading...