Body Solid G3S - Page 24

8
Be careful to assemble all components
in the sequence they are presented.
mm
Inch
24
STEP
NOTE:
Leave all pulley bolts hand tight until step 13
A. Install Pulley (A3) into Seated Press Arm Support (P) as shown using:
One 41 (3/8” x 7” hex head bolt)
Two 57 (3/8” washer x 3/4” o.d.)
Two 17 (spacer sleeve)
One 51 (3/8” nylon lock nut)
B. Install Pulley (A5) into Seated Press Arm Support (P) as shown using:
One 41 (3/8” x 7” hex head bolt)
Two 57 (3/8” washer x 3/4” o.d.)
Two 17 (spacer sleeve)
One 51 (3/8” nylon lock nut)
C. Install Pulley (A8) into the pulley flange on Top Weight Stack Frame (N) as shown using:
One 44 (3/8” x 1 3/4” hex head bolt)
Two 55 (3/8” washer)
One 51 (3/8” nylon lock nut)