ELLIPTICALS – USER MANUAL
6.3 KEYPAD TEST
The KEYPAD TEST allows you to verify if each key on the console is functioning correctly. During the
test, when you press on a console key a confirmed response labeling that key should appear on the
screen. For example, if you press the INCREASE LEVEL key, the screen should display LEVEL
INC. Test the various keys and ensure the correct response appears on the screen.
6.4 DISPLAY TEST
The DISPLAY TEST allows you to verify if each part of the LCD display is functioning correctly.
Once the DISPLAY TEST has been selected the test will begin. During the test, the screen will light
up in a certain pattern; check that all segments in the pattern are functioning correctly. Proceed to the
next pattern by pressing the INCREASE/DECREASE SEGMENT key until all patterns have been
completed and checked.
6.5 HEART RATE TEST
The HEART RATE TEST allows you to verify if the two heart rate systems, wireless chest strap and
contact heart rate sensors, are functioning correctly.
Once the HEART RATE TEST has been selected the test will automatically begin.
Place your hands on the contact heart rate sensors and after 10 seconds your heart rate
should be displayed in the bottom center of the display.
Put on a compatible wireless heart rate chest strap. If a heart rate chest strap signal is
detected by the wireless receiver in the console the value will be displayed in the bottom left-
hand side of the display.
If either system does not function or is erratic, refer to Heart Rate Troubleshooting in section 8.3.
6.6 SOUND TEST
The SOUND TEST allows you to verify if the beeper in the console is functioning correctly.
Once the SOUND TEST has been selected the test will automatically begin. A series of beeps should
be heard if everything is functioning correctly. Press any key to end the test.
6.7 USB PORT TEST
The USB TEST allows you to verify if the USB port and software is functioning correctly.
If the USB port is empty or not communicating correctly then USB TEST FAILED appears.
If a USB device is in the port and communicating correctly then USB TEST OK appears on screen.
Remove and insert the USB several times to confirm that the USB Port is working consistently.
6.8 BRAKE TEST
The Brake test will check if the Resistance System is operating correctly.
When the test begins, Level 1 will be displayed on the right hand side of the screen.
While pedaling increase the level to Level 20 ensuring that the resistance increases with the value.
6.9 SPEED SENSOR TEST
The speed sensor test allows you to see whether your speed sensor circuit is functional or not.
To Next Page
Loading...