Bodyguard T240S User Manual (English)

Other manuals for Bodyguard T240S

Questions and Answers:

S
Sharon OlsonJul 31, 2025
What to do if my Bodyguard Treadmill computer will not light up?
- K
  Kaitlin MaloneJul 31, 2025
  First, ensure the treadmill is plugged into a functioning wall socket. Test the socket with a lamp. Check the circuit breaker and reset it if necessary. Inspect the power cord for damage and replace it if needed. See if the switch lights up when turned on. If these steps don't resolve the issue, turn off and unplug the treadmill, then remove the cover to check and properly connect the wires. If the issue persists, it might be a damaged lower control board.
J
Jacob GonzalesAug 5, 2025
Why is my Bodyguard T240S belt speed not constant?
- L
  lisagrantAug 5, 2025
  The belt might be sticking because it needs cleaning or lubrication. Another cause could be that the running belt tension is too loose. To check this, remove the motor cover and see if the motor flywheel slows down at the same time as the running belt. If it does, tighten the running belt by turning both the left and right rear roller screws ¼ turn clockwise and test. Repeat if needed, but don't exceed two full rotations to avoid overstretching the belt. The motor or lower control board may also be damaged, or the drive belt may be loose.
J
Jake LeachAug 10, 2025
What to do if my Bodyguard Treadmill console lights up but the belt does not turn?
- N
  Nicole OrtizAug 10, 2025
  Make sure the magnetic key is properly inserted. If the issue persists, it might be a damaged lower control board.
J
jessewoodsAug 15, 2025
Why does my Bodyguard Treadmill belt track left or right?
- A
  Angela EstradaAug 15, 2025
  This issue can occur if the treadmill is placed on an uneven floor. Try moving it to an even surface. Alternatively, the rear roller might need adjustment, or the belt alignment may be incorrect.
W
Wendy PatelAug 19, 2025
Why does the incline on my Bodyguard Treadmill not respond properly?
- T
  Timothy LopezAug 19, 2025
  Check if the incline motor wires are properly connected to the lower control board. Also, the incline might need to be calibrated.