Bodyguard T280S User Manual (English)

Other manuals for Bodyguard T280S

Questions and Answers:

R
Robert PetersenAug 6, 2025
What to do if my Bodyguard Treadmill computer will not light up?
- D
  Darren GainesAug 6, 2025
  First, ensure the treadmill is plugged into a functioning wall socket. Test the socket with a lamp. Check the circuit breaker and reset it if necessary. Inspect the power cord for damage and replace it if needed. See if the switch lights up when turned on. If these steps don't resolve the issue, turn off and unplug the treadmill, then remove the cover to check and properly connect the wires. If the issue persists, it might be a damaged lower control board.
P
peterssheilaAug 11, 2025
Why is my Bodyguard Treadmill belt speed not constant?
- M
  Michael GilmoreAug 11, 2025
  The belt might be sticking because it needs cleaning or lubrication. Another cause could be that the running belt tension is too loose. To check this, remove the motor cover and see if the motor flywheel slows down at the same time as the running belt. If it does, tighten the running belt by turning both the left and right rear roller screws ¼ turn clockwise and test. Repeat if needed, but don't exceed two full rotations to avoid overstretching the belt. The motor or lower control board may also be damaged, or the drive belt may be loose.
C
cmccoyAug 16, 2025
What to do if my Bodyguard Treadmill console lights up but the belt does not turn?
- J
  Julia NielsenAug 17, 2025
  Make sure the magnetic key is properly inserted. If the issue persists, it might be a damaged lower control board.
B
blyonsAug 21, 2025
Why does my Bodyguard T280S Treadmill belt track left or right?
- J
  Juan SimmonsAug 21, 2025
  This issue can occur if the treadmill is placed on an uneven floor. Try moving it to an even surface. Alternatively, the rear roller might need adjustment, or the belt alignment may be incorrect.