Bodyguard V6X - Component and Sensor Tests

V6/R6 BIKES OWNER’S MANUAL
27
(Dedicated Heart Rate Window).
3. Do the same for the hand grip system; put your hands on the two metal plates and wait 5 to 10 seconds; your heart rate
signal will be displayed on the scrolling screen window
4. Press
STOP
key to terminate the test.
CLOCK TEST
The clock test allows you to verify the clock chip and circuitry.
1. In the DIAGNOSTICS menu, select clock test and press the
JustGo™
key to accept.
2. The computer will display the message: CLOCK TEST SUCCEEDED
3. Press
STOP
key to terminate the test
SMART CARD TEST
The smart card test allows you to verify that the smart card slot and circuitry is able to read or write information from or on a
smart card. You must use a smart card user type.
1. In the DIAGNOSTICS menu, select smart card test and press the
JustGo™
key to accept.
2. Insert smart card. The message SMART CARD GOOD will appear.
3. Press
STOP
key to terminate the test.
SOUND TEST
The beeper test will cause the beeper to sound.
1. In the DIAGNOSTICS menu, select sound test and press the
JustGo™
key to accept.
2. Listen for a series of beeps. Press any key to terminate the test.
BRAKE TEST
The brake test allows you to feel if the braking system is performing according to the percentage of brake required onscreen.
1. In the DIAGNOSTICS menu, select brake test. To start the test, press the
JustGo™
key.
2. Vary the brake resistance from 0% to 100% by pressing the
INCREASE/DECREASE SEGMENT
key. Ensure that pedal
resistance matches the selected setting (0, 25, 50, 75, or 100).
3. Press
STOP
key to terminate the test.
SPEED SENSOR TEST
The Speed Sensor test allows you to see whether your speed sensor circuit is functional or not. In the DIAGNOSTICS menu,
select SPEED SENSOR TEST and press the
JustGo™
key to accept.
1. A message will be displayed on the scrolling screen indicating whether the sensor is functioning properly or not.
• Check to make sure your speed sensor is connected.
• Check to make sure the sensor is not dirty.
2. Operate the pedals. Once the computer has finished counting, it will display the following message: THE SENSOR IS OK.
3. Press
STOP
to terminate the test.
STATISTICS
The statistics allow you to view various parameters related to the use of your elliptical, such as time and distance.
1. In the DIAGNOSTICS menu, select statistics and accept it by pressing
JustGo™.
• The TOTAL DISTANCE displayed indicates the total distance traveled with the elliptical during all exercise programs
(XX.XX miles).
• The TOTAL TIME displayed indicates the amount of time the treadmill has been used during all exercise programs (XX
Months – XX Day - XX Hours - XX Min).
2. Press
STOP
key to terminate the test.