BODYMAX TM50 - Page 20

20
TM50
Step 6: Alignment of the Feet
If the oor is uneven, you can stabilize the treadmill by turning the two setting screws under the
main frame.
⚠ WARNING
The treadmill is equipped with high-pressure shock absorbers that can cause the treadmill
to suddenly open if handled incorrectly. For more information, refer to the section 2.1 of this
manual.
1. Lift the treadmill on the desired side and
rotate the setting screws under the main
frame.
2. Rotate the screws clockwise in order to
remove them and to raise the running
surface.
3. Rotate them counterclockwise in order
to lower the running surface.
Step 7: Connecting the Equipment to the Mains supply
࣑ ATTENTION
The equipment must not be connected to a multiple socket, otherwise it
cannot be guaranteed that the equipment will be supplied with sucient
power. Technical errors can result.
Plug the power plug into a wall outlet that complies with the instructions in the
chapter on electrical safety.
Correctly Getting On and O
1. To step onto the treadmill, grip the handrails with both hands and step onto the treadmill one
foot at a time.
2. To get o, grip the handrails with both hands and step o the treadmill one foot at a time.
Down
Up