Operating instructions for S 40-3...S 150-3 series screw compressors Page 13
General information 1.2 Introduction
Intended use
Foreseeable misuse
Transport damage
BOGE does not accept any liability for breakage or transport damage. Please
inspect the compressor immediately after delivery and direct damage claims
to the last haulier – even if the packaging is not damaged! To safeguard claims
against the haulier we recommend leaving the machine, devices and packing
material in the same condition they were in when the damage was detected.
In the event of any other complaints, please inform us within six days of the
arrival of the delivery.
WARNING!
BOGE compressors, including their accessory equipment, are exclusively
intended for the compression of air in industrial applications. The air taken
in must not contain any explosive or chemically unstable gases or vapours.
Do not exceed the specified end of compression temperature.
BOGE compressors are designed for stationary operation.
Ensure that they are installed and operated in dry and clean rooms only.
The emergency stop device of the compressor (emergency stop switch/
button) is exclusively intended to switch off the compressor in case of emer-
gency.
Operation and control are designed to be carried out by trained and author-
ised operators.
WARNING!
Never direct the compressed air generated towards persons.
This can be life-threatening!
Oil is injected into the pressure chambers of the compressor.
Only use the compressed air generated for breathing purposes, or allow it to
come into contact with foods, if it was treated appropriately beforehand.
This BOGE compressor is not explosion-protected.
Do not operate in explosive areas or in a potentially explosive atmosphere!
Do not operate the compressor in rooms in which extreme dust, toxic or flam-
mable vapours and gases may occur.
The emergency stop device of the compressor (emergency stop switch/but-
ton) must not be used as a normal means of switching the compressor off.
Use the OFF button to switch the compressor off normally.
The following is not permitted:
– Compressing other media than those specified as the intended use or air
containing contaminants.
– Exceeding the end of compression pressure indicated on the type plate.
– Altering the safety devices and safety covers, or putting them out of oper-
ation.
– Removing or painting over signs and symbols on the compressor.
– Operation of the compressor by unauthorised or untrained persons.
To Next Page
Loading...
Need help?
General
