EN
29
Solution: Not every highly reflective or mirrored
glass can be measured. The measurement
might be successful from the rear side of
the glass.
n
“Memory full”
– This error message appears when all 250
memory slots are full. If you have saved the
average measurements, they will occupy
several storage locations!
Solution: Before saving more data, you should
transfer the saved measurement results to
your PC and then delete all data saved in
the GlassBuddy (see section 5).
n
“Glass outside measuring range”
– This error message appears if the complete
structure of the pane exceeds the measuring
range of 50 mm. (This message will only
appear on the GlassBuddy Basic version).
Solution: Software upgrade to GlassBuddy Plus
n
“Error”
– This error message appears if there is an
internal error in the GlassBuddy.
Solution: If the message Error is repeated, the
GlassBuddy should be returned to the
manufacturer for inspection.
n
“No Data”
– This message appears if there is no data in the
memory that can be shown.
n
“Measurement in Basic mode not possible”
– This error message appears if types of
glass are being analysed which can only be
measured with GlassBuddy Plus.
Solution: Software upgrade to GlassBuddy Plus
09 Charging the Battery
When the battery is fully charged, the device can
work permanently for at least 8 hours. When
charged, the battery usually lasts for one to two
weeks under normal conditions of use. At a battery
status of approximately 10%, you will be shown the
message “Charge battery”. Measurements can still
be taken but the GlassBuddy should be charged as
soon as possible to ensure problem-free operation.
For charging the battery, connect the GlassBuddy
with the supplied USB cable to a suitable USB port.
The USB port used must be able to provide 5V,
500mA.
When the battery is almost empty, it takes appro-
ximately 120 minutes to charge it to 100% again
(if the GlassBuddy remains switched on during
charging, the charging time is longer). The
GlassBuddy will indicate when the charging
process is over. The display will then show PC con-
nection - battery is charged. Nevertheless the
GlassBuddy has to be switched on for displaying
this message.
The GlassBuddy contains a permanently installed
top quality Li-ion rechargeable battery with a very
long service life. If the performance of the battery
diminishes over the years, Bohle can replace it.
10 Care and Maintenance
To avoid damage or malfunctions of your
Glass Buddy, please strictly observe the following:
n
The GlassBuddy must always be stored in the
supplied carrying case as this is the only way to
effectively prevent damages.
n
To avoid damage, the GlassBuddy must only be
operated and/or stored at temperatures between
+5°C and +40°C.
n
The GlassBuddy must not be exposed to vibra-
tions or impacts.
n
The GlassBuddy is neither dust- nor waterproof.
Therefore keep it away from the relevant
sources of contamination.
n
Only clean the display window and casing with a
dry, clean and soft cloth. Under no circumstan ces
must cleaning liquids, thinning or abrasive
agents be used for cleaning.
n
The laser opening and the sensor slit may only
be cleaned carefully (!) with a dry, clean and soft
brush or with clean compressed air.
To Next Page
Loading...