What to do if the hydraulic aggregate cannot be started on my Bomar Saw?
If the hydraulic aggregate cannot be started on your Bomar Saw, the auxiliary contact on thermo-relay FA1 may be defective. Replace the defective contact on motor starter FA1.
What to do if my Bomar Saw band drive cannot be started?
If the saw band drive on your Bomar Saw won't start, it could be due to a wrongly adjusted or defective pressure switch. Try setting the pressure switch or replacing defective parts.
Why is the cut not finished with my Bomar Saw?
If your Bomar Saw's cut is not finished, it could be due to a wrongly adjusted lower stop point of the saw frame or a messed-up stop point surface. Check the lower limit switch and screw, and cleanse the stop point surface of the limit switch from debris and residue material.
How to troubleshoot short lifetime of the saw band on my Bomar Saw?
A short lifespan of the saw band on your Bomar Saw can be caused by: * Insufficient or over stretched saw band. * Worn or wrongly adjusted swarf brush. * Wrongly adjusted or worn hard metal guides.
What causes insufficient cut output on my Bomar Saw?
Insufficient cut output on your Bomar Saw may be caused by a worn saw band, the wrong saw band tooth system, or wrongly set down feed and speed of the saw band. Replace the saw band, keeping the manufacturer's instructions in mind, and set the feed and speed according to the saw band manufacturer's values.
What to do if my Bomar Saw is cutting downing?
If your Bomar Saw is cutting downing, this could be due to the geometry of hardmetal guiding cubes being wrongly adjusted or bearings of guiding cubes are used. The hardmetal guiding cubes must be adjusted and bearings of guiding cubes must be replaced.
What to do if electric motor and pump are without voltage on my Bomar Saw?
If the electric motor and pump are without voltage, and there is no voltage between the contactor and thermal protector on your Bomar Saw, the contactor may be wrong. Replace contactor of engine.
Why is the protector switched off from engine hydraulic aggregate MA3 sometimes on my Bomar Saw?
If the protector is switched off from engine hydraulic aggregate MA3 sometimes on your Bomar Saw, it may be due to high working pressure into hydraulic system. A service engineer must reduce the pressure in hydraulic system.
How to troubleshoot cleansing of the saw band if it is not functional on Bomar Saw?
If the cleansing of the saw band is not functional on your Bomar Saw, it might be because the elastic wheel of the brush drive or the knurling of the driving wheel is worn-down, or the shaft of the brush drive is rusted. Replace the elastic wheel or the driving wheel as needed. Clean and oil the shaft of the brush.
What to do if the cut is not cut upon desired angle with my Bomar Saw?
If the cut is not cut upon desired angle with your Bomar Saw, it may be caused by: * A loosened securing lever. * A set angle that does not match the cut angle. * Insufficient saw band stretching. * Loosened guiding arm and guiding cube. * Dirt between material and clamping jaw.
To Next Page
General