5. This item requires a 20 lb. propane
tank (not included) in order to operate
correctly. To install the tank to the body
(B), first turn the cylinder valve on the
tank clockwise to close the gas supply
on the gas cylinder. Then, screw the
regulator coupling from inside the
body (B) onto the valve clockwise by
hand only. Make sure it is fastened.
2. From underside of lid (A), place spring washer (BB)
and then flat washer (CC) onto threaded part of
handle (D). Secure with M6 nut (DD), tightening
with wrench (E).
3. Place pumice stones (C) into body (B).
4. Put the gas tank in the metal stand. Make sure
the gas tank sits on the metal stand completely.
Turn the wing screw on the outer part of metal
stand clockwise to secure the gas tank tightly.
BB
CC
BB
CC
To Next Page
Loading...
