Boneco H700 - Malfunctions and Troubleshooting

34
en
Problem Possible cause Action
Air has an unpleasant
odor
Stagnant water in the tank and water base Empty and thoroughly clean the appliance
No improvement in air
quality
Particle sensor is dirty Clean the particle sensor
Open windows or doors Close windows and doors
Display shows Error E2 Fan blade blocked or motor is defective Unplug the appliance, check that the fan blade can turn freely, plug the
appliance back in; contact a service center if the problem persists
Display shows Error E3 Drum blocked or motor is defective Unplug the appliance, check that the drum can turn freely, plug the appliance
back in; contact a service center if the problem persists
Display more frequent-
ly shows symbol for
water change
Water has been in the water base for more than
4 days without operation
Empty the appliance if it is only operating in the air purification mode
Water was not changed after cleaning (see
page 27)
Change water after each cleaning (see page 27)
MALFUNCTIONS AND TROUBLESHOOTING