Bones Milestone 312 Ace - Delete Files and Folders

15
The linkage of folders with a certain key combination can be achieved by navigating to the desired folder,
then select it with the "Mode" button.
Now hold the "Selector" button and press in addition one of the 5 front buttons. If you hold down the two
buttons for 3 seconds, the device will accept the selected location and confirm that the previously pressed
key combination has been assigned to one of five preset folders.
Overall, you can assign five folders with a hotkey and select them directly. To select a preset folder later,
press "Selector" and tap in addition briefly on the correspondingly assigned front button.
Note: The five available shortcuts may already be assigned to specific folders in delivery of the unit. This
assignment can be changed at any time.
4.1.1.4. Naming folders via Voice Recording
You can rename the folder name directly via voice recording in your own voice or assign the label on the
computer and read aloud via text-to-speech. To assign a folder name using voice recording, first select the
folder with the "Mode" button. Now hold down the "Rec" button. Once you hear a clicking sound, hold the
"Rec" and the "Mode" buttons until the message "Folder" is heard. Then you can select the desired folder
name and speak into the microphone, then release the two keys. The stop recording is signaled by the
tone sequence "high-low". Next time you navigate to the named folder, your voice recording will sound as
the folder name. You can overwrite the recorded label attached to any folder as often as you like. To
remove a recorded folder name, delete the file "FOLDER.NAM" in the folder using a computer.
You can re-record previously deleted folder names directly using your Milestone 312 Ace, if you re-record
the folder in question previously by renaming it as just described with "Rec" and "Mode". Then you will be
able to erase the recorded voice label with the key combination "Mode" and "Play". The folder is then
again assigned to the computer name.
Tip: An SD memory card can also be labelled with your voice. Pres "Rec” several times " until you get to
the top level and switch to "External Memory". Perform the same sequence of how to designate a label for
the folder. After that, your recorded name will be announced when the SD card is inserted.
Note: If a folder name has been specified both on the computer, as well as by voice name, only the
voicename is played.
4.1.1.5. Fast Jump
Fast Jump is a navigation function, which is applicable within the application "Audio" in each file. Fast
Jump is especially useful for large files, because then you can jump quickly to a desired portion. To start
Fast Jump, during the playback of a file, hold down the "Selector" button and tap "play". With this key
combination you are now jump directly to the center of the current file. This Fast Jump is active while the
"Selector" button remains depressed throughout its operation, otherwise Fast Jump is terminated.
Therefore, Keep "Selector" pressed in order to determine the position in the file. With the "Left arrow" you
now get into the middle of the first half. This means you can reach the first quarter, or 25% of the file.
Suppose, however at times, that you have the "Right arrow" pressed and thus arrived at 75% of the file. If
you press the "Left arrow" you reach 62.5% of the file, so the middle of 50% and 75%. You can proceed
with this division until you reach the desired entry point. After each time you press one of the arrow keys,
the playback will start automatically, so you have an idea of where you are right now. If you press "Play"
while the "Selector" button continues to be held, this will take you back to the middle of the file.