12
Using your GoTime
This section gives you the information you need to enjoy your ride: how to see
the modes of the GoTime, and how to start your ride.
Viewing the screens
These steps start with Speed/Clock mode, which is what you see after completing
the Setup Procedure. However, you can start on any step shown here. Note that
speed always displays.
To change a screen, press
M
:
Clock >
This is the time of day.
Timer > This is the amount of time you have been riding after you last restarted the trip data.
The timer starts when the wheel turns.
Trip distance > This is the distance you have ridden after you last restarted the trip data,
displayed to the tenth.
Odometer > This is the distance you have ridden since you last re-set the computer by
performing the set-up procedure, rounded to whole miles or kilometers.
Average speed > This is your average speed during this trip.
Starting Your Ride
Before a ride, you may want to set your trip information to zero (0). This is
called a ‘restart.’ The trip information includes trip distance, elapsed time, and
average speed.
1. In any screen, hold
M
for two seconds.
To Next Page
Loading...
