Bontrager Ion Pro - Flare RT Reset Function; Flare RT Wireless Communication; General Bicycle Safety Warning; European Union Compliance

To Previous Page

Reset

To reset the light to factory default settings, with the light on, press and hold the power button for 15

seconds. The main LED will flash once at 8 seconds, and again at 15 seconds. Release the button after

the second flash.

Wireless Communication

The light is shipped with ANT+ and Bluetooth wireless connectivity enabled. To disable, with the light

off, press and hold the power button for 15 seconds. The main LED will flash once at 8 seconds, and

again at 15 seconds. Release the button after the second flash.

NOTE: The status LED flashes blue every 15 seconds when wireless

is enabled.

WARNING

A bicycle without correct lights and reflectors might be difficult for other people to see, and you might

not be able to see. If you cannot see, or other people cannot see you, you could have an accident.

Make sure your lights operate correctly and that batteries are charged.

European Union Compliance

Ion Pro RT and Ion 200 RTdo not comply with German StVZO regulations! Trek Bicycle Corporation and

Bontrager hereby declare that the wireless device identified as ‘Ion Pro RT’, ‘Ion 200 RT’ and ‘Flare

RT’are in compliance with the following European Directives:

Radio Equipment Directive 2014/53/EU (Ion Pro RT only)

EMC Directive 2014/30/EU

Low Voltage Directive 2014/35/EU (Ion Pro RT only

RoHS Directive 2011/65/EU

The full text of the EU declaration of conformity is available from your dealer, or at the following

internet address: http://www.trekbikes.com/support

Related product manuals

Bontrager Backrack Series

2 pages

Bontrager Transmitr MicroRemote

2 pages

Bontrager Ion Pro - Flare RT Reset Function; Flare RT Wireless Communication; General Bicycle Safety Warning; European Union Compliance

Table of Contents

Related product manuals