Why can't I insert a disc into my Booster Car Video System?
If you cannot insert a disc into your Booster Car Video System, it may be because there is already a disc inside the unit. Eject the current disc and then insert the new one.
Why does my Booster BDVM-8455MPBTV Car Video System unit keep blowing fuses?
If your Booster Car Video System unit blows a fuse, it could be due to the yellow or red wire, or speaker wires touching the chassis ground. Check for any pinched wires. It could also be due to an incorrect fuse rating. Ensure you are using a fuse with the correct rating.
What to do if my Booster BDVM-8455MPBTV has power but no audio?
If your Booster Car Video System has power but no or low audio output, start by checking the speaker wire connections at the speakers. Ensure that none of the speaker wires are touching each other or the chassis ground; insulate any bare wires to prevent this. If the problem persists, review the wiring diagram and check if the speakers are damaged.
Why is the sound quality poor on my Booster BDVM-8455MPBTV?
If your Booster Car Video System exhibits poor sound quality or distortion, it might be due to the speaker power rating being incompatible with the unit. Ensure you connect proper speakers. Also, check the speaker wire contact, as the speaker might be shorted.
Why is there no video when reversing with my Booster Car Video System?
If there is no video display on your Booster Car Video System when in reverse, check the connections at the reverse lamp to ensure the reverse circuit is properly connected. Also, make sure the vehicle is actually in reverse gear.
Why does my Booster Car Video System only have audio in reverse?
If your Booster Car Video System has audio only when in reverse, check the connections at the parking brake to ensure the parking brake safety circuit is connected. Also, make sure to apply the parking brake.
What does 'Bad Disc' mean on my Booster Car Video System display?
If 'Bad Disc' appears on the display of your Booster Car Video System, it indicates a focus error. Press eject or RESET.
Why won't my DVD play on my Booster Car Video System?
If a DVD does not start playback on your Booster Car Video System, it could be due to several reasons: the disc may be warped or scratched (use a disc in good condition), dirty or wet (clean the disc with a soft cloth), incompatible (use a compatible disc), the disc rating exceeds the Parental Lock rating limit (change Parental Lock settings), the disc region code is not compatible (use a disc with the proper region code), or the disc is inserted upside down (insert the disc with the label side up).
How to correct the image ratio on my Booster BDVM-8455MPBTV?
If you experience a prolonged image or improper height/width ratio display on your Booster Car Video System, check the wiring and correct any improper video signal connections. Also, use the correct aspect ratio setting.
What to do if the front panel of my Booster Car Video System won't open or close?
If the front panel of your Booster Car Video System will not open or close, it may be obstructed. Remove the obstruction and press OPEN to resume the monitor open/close sequence.
Essential safety guidelines and precautions for installation and usage.
Critical warnings regarding product use, electrical safety, and environmental exposure.
Important cautions and warnings for safe and correct wiring procedures.
List of necessary tools and supplies for installing the unit.
Detailed steps for installing the unit using different methods.
Description of the base panel controls and the reset button functionality.
Detailed explanation of each button's function on the remote control.
Instructions for replacing the battery in the remote control.
Step-by-step guide to calibrate the touch screen for accurate input.
Configuration settings for DVD playback, including system and language.
Steps for pairing, connecting, and managing Bluetooth devices.
Instructions for playing music and videos from an iPod.
Adjusting screen brightness, contrast, tint, and color.
Settings for treble, bass, balance, fader, and buzzer.
Configuring the clock display and time mode (12/24 hour).
Setting up screen saver images and activation time.
Configuring radio area, GUI, EQ, LOUD, and default system settings.
General| Touch Screen | Yes |
|---|---|
| Bluetooth | Yes |
| USB Port | Yes |
| SD Card Slot | Yes |
| DVD Player | Yes |
| Radio Tuner | Yes |
| Rear Camera Input | Yes |
| Steering Wheel Control | Yes |
| FM Radio | Yes |
| Power Output | 4 x 45W |
| Compatibility | Universal |
| Resolution | 800 x 480 |
| Screen Type | TFT LCD |
| Supported Media Formats | MP3, WMA, AVI, JPEG |
To Next Page
