Pagina 13 di 36 OMP68017 Rev. D 24/12/17
STS INSTALLATION
1) On receipt of the goods, check the packaging. Any missing content, damage or
other problems must be reported to the shipping company or to the dealer as soon
as possible.
2) Check that the device received is actually what was requested in your order
3) Place the STS inside the frame.
4) Connect the loads to the output sockets of the STS, if possible distribute them
evenly.
5) Check that all parameters are within the specified limits.
6) Check that the maximum load does not exceed the product specifications.
STS/ITS
To Next Page
Loading...