Pagina 5 di 36 OMP68017 Rev. D 24/12/17
SAFETY INSTRUCTIONS
IMPORTANT: Safety instructions
This manual contains important safety information. Carefully follow the instructions when
handling, installing, using and maintaining the device. Please read the product manual
carefully before installation.
Keep the instructions.
- Check the device at the time of receipt and report any damage or malfunction to your
dealer. Do not install the device if there are any signs of damage.
- Use a suitable device for handling the device according to its weight and dimensions
Improper use of loads can create risks for the operator.
- Switch off the device and disconnect the power supply and signal connections during
handling.
- Install the device in a closed, dust-protected area. The device is not meant for outside
installation. Ensure that the installation site meets the following environmental conditions:
temperature: 0-40°C, relative humidity 0-90% without condensation.
- Do not expose the device to direct sunlight; do not obstruct the ventilation ducts of the
crankcase. High ambient temperatures can reduce battery life and jeopardize the
operation of the device.
- Do not install the device in places where there are flammable or explosive agents.
- Do not install the device in places where saline or corrosive agents are present.
- The vibrations and impacts can compromise the safety and operation of the device.
Locate a secure site for installation.
- Do not position anything on the device.
- Do not pour liquids into the outer surfaces of the device and in the grooves of the
housing.
- Always disconnect the equipment and check that there are no potential hazards before
carrying out any maintenance work. If the device contains storage devices, input and
output ports may remain energized even after disconnection.
- Always use protective equipment and remove personal items such as bracelets, watches,
and jewels before performing ordinary and extraordinary maintenance. Do not remove
protective covers if not required for maintenance.
- The maintenance operations mentioned in the user manual must be performed by
qualified personnel.
- Repair operations invalidate the warranty. Always contact your dealer or authorized
service centre.
- Make sure that the power supply is earthed and that the electrical characteristics meet
the nominal ratings required for the equipment.
- Make sure that the connecting cables comply with the country's
- Installation standards. Do not use worn or damaged connection cables.
- Do not use the device to supply medical devices whose operation may be hazardous to
the health or life of the patient.
To Next Page
Loading...
General