18.
Disconnect plug from power source
before performing any assembly,
adjustment or repair to avoid possible injury.
Slide Action Adjustment
1. Locate the 4 Set Screws (A, B, C, & D) on the Rail
Guide Housing. (Figure 1)
2. Loosen the Nut on Set Screw (A) with an
adjustable wrench.
3. Tighten or loosen Set Screw (A) with the 4mm end
of the bit on the multi-purpose tool until you
achieve minimal slide play while maintaining the
desired sliding force.
4. After adjusting Set Screw (A), hold Set Screw (A)
with a 4mm allen key and tighten the nut with an
adjustable wrench without moving the Set Screw.
(Figure 2)
5. Complete steps 2-4 with the remaining set screws
in order as shown in figure 1.
Adjustments (continued)
Figure 1. Set Screws
Figure 2. Adjust and Tighten Set Screw
WARNING
!
To Next Page
Loading...
