Bosch 520 Series - Repair and Disposal

Automatic Detectors LSN improved Maintenance and Service | en 27
Bosch Sicherheitssysteme GmbH Operation Guide 2019.11 | 4.0 | F.01U.025.877
2. Now hold the test device under the detector so that the test beaker is flush with the trim
ring. By covering the scattered light areas, both optical sensors are triggered
simultaneously (no Otesting gas is required).
3. The detector triggers the alarm and the red alarm LED flashes.
Notice!
In the case of programmed intermediate alarm storage, longer trigger times occur.
5.5 Repair
In the event of any defect, the entire module/device is exchanged.
5.6 Disposal
Unusable electrical and electronic devices/modules must not be disposed of
with normal household refuse. They must be disposed of in compliance with
the applicable regulations and directives (e.g. WEEE in Europe).
Packaging Film of the Fire Detectors with Csensor:
The packaging bag of the multisensor detectors with Csensor consists of tear‑resistant
PE‑ALU laminated film and may be disposed of with the household garbage.