22/52 Transport and storage
Bosch Rexroth AG, A2FM/A2FE Series 70, RE 91071-01-B/03.2015
You can hoist the axial piston unit as shown in Fig. 4 with the eye bolt screwed into
the drive shaft.
Fig. 4: Fixing the eye bolt
WARNING! Danger from suspended loads!
During transport with a lifting device, the axial piston unit can slip out of the lifting
strap and result in injury.
▶ Use the widest possible lifting strap.
▶ Make sure that the axial piston unit is securely fixed with the lifting strap.
▶ Only guide the axial piston unit by hand for fine positioning and to avoid oscillations.
▶ Never stand or put your hands under a suspended load.
▶ Place the lifting strap around the axial piston unit in such a way that it does not
pass over attachments (e.g., valves, piping) and that the axial piston unit is not
suspended from attachments (see Fig. 5).
Fig. 5: Transport with lifting strap
Transport with lifting strap
To Next Page
Loading...
