6/52 About this documentation
Bosch Rexroth AG, A2FM/A2FE Series 70, RE 91071-01-B/03.2015
Table 1: Required and supplementary documentation
Title Document number Document type
Information for the use of hydrostatic drives at low temperatures
Contains additional information on the use of Rexroth axial piston units at low
temperatures.
90300-03-B Manual
Storage and preservation of axial piston units
Contains additional information on storage and preservation.
90312 Data sheet
1.3 Presentation of information
Standardized safety instructions, symbols, terms and abbreviations are used
throughout this documentation so that you can work quickly and safely with your
product. To give you a better understanding, these are explained in the sections below.
1.3.1 Safety instructions
This documentation includes safety instructions in Chapter2.6 “Validity of
documentation” on page12 and in Chapter3 “General information on property
damage andproduct damage” on page15 and before a sequence of actions or an
instruction involving a risk of personal injury or damage to equipment.
The steps described to prevent danger must be followed.
Safety instructions are set out as follows:
SIGNAL WORD
Type and source of danger!
Consequences of failure to observe
▶ Steps to prevent the danger
• Warning sign: draws attention to the danger
• Signal word: identifies the degree of danger
• Type and source of danger: identifies the type and source of the danger
• Consequences: describes what will happen if the safety instructions are not followed
• Precautions: states how the danger can be avoided
To Next Page
Loading...
