RE-A 91610/12.2015, Bosch Rexroth Corp.
Features
▶ Variable motor with axial tapered piston rotary group of
bent-axis design, for hydrostatic drives in open and
closed circuit
▶ For use in mobile and stationary applications
▶ The wide control range enables the variable motor to
satisfy the requirement for high speed and high torque.
▶ The displacement can be infinitely varied from V
gmax
to
V
gmin
=0.
▶ The output speed is dependent on the flow of the pump
and the displacement of the motor.
▶ The output torque increases with the pressure differen-
tial between the high and low-pressure side and with
increasing displacement.
▶ Wide control range with hydrostatic transmissions
▶ Wide selection of control devices
▶ Cost savings through elimination of gear shifts and
possibility of using smaller pumps
▶ Compact, robust motor with long service life
▶ High power density
▶ Good starting efficiency
▶ Version with 9-piston rotary group
▶ Good low speed characteristics
▶ High uniformity
▶ Sizes 60 to 215
▶ Nominal pressure 6500psi (450bar)
▶ Maximum pressure 7250psi (500bar)
▶ Open and closed circuits
Axial piston variable motor
A6VM series 71
RE-A 91610
Edition: 12.2015
Replaces: 04.2013
Contents
Type code 2
Hydraulic fluids 5
Flow direction 6
Shaft seal 6
Operating pressure range 7
Technical data 8
HP – Proportional hydraulic control 10
EP – Proportional electric control 13
HZ – Two-point hydraulic control 15
EZ – Two-point electric control 16
HA – Automatic high-pressure related control 17
DA – Automatic speed-related control 22
Electric travel direction valve (for DA, HA.R) 24
Dimensions size 60 25
Dimensions size 85 31
Dimensions size 85 32
Dimensions size 115 38
Dimensions size 150 44
Dimensions size 170 50
Dimensions size 215 56
Connector for solenoids 62
Flushing and boost pressure valve 63
Counterbalance valve BVD and BVE 65
Speed sensor 69
Setting range for displacement 70
Installation instructions 72
Project planning notes 74
Safety instructions 75
Americas
To Next Page
Need help?
General