Need help?Do you have a question about the Bosch C 70 and is the answer not in the manual?
General| Brand | Bosch |
|---|---|
| Model | C 70 |
| Category | Data Loggers |
| Language | English |
Details CAN bus settings and capabilities for data transmission.
Describes Ethernet and serial port functionalities and uses.
Lists pin assignments for the vehicle diagnosis connector.
Overview of analog and frequency input parameters, including voltage and filtering.
Guides for setting up linear, nonlinear, and multipoint analog sensors using wizards.
Explains the digital filtering process for analog signals and its effects.
How to configure frequency inputs like wheel speed sensors.
Setting up computed channels for calculations like speed and sensor values.
Configuration and use of the hysteresis function to prevent signal switching.
Steps to configure the calculation of vehicle speed from input sources.
Steps to create and arrange measurement sheets in RaceCon for live data viewing.
Procedures for calibrating analog sensors and multipoint adjustments.
Methods to view and manage device error logs.
Details on error types, locations, and status indicators.
Monitoring analog input states for faults like shorts or open lines.
Summary of hardware and performance characteristics like processor and memory.
Comprehensive list of connector pin functions and their status.
Initial steps for setting up the RaceCon software and creating a new project.
How to activate optional device features using provided keys.
Guide for performing the initial recording and importing data into analysis software.
Procedure to synchronize the logger's internal clock.
Steps to configure channels for receiving data from the CAN bus.
How to set up outgoing CAN messages and channels.
Using multiplexers to manage and transmit CAN data efficiently.
Setting up recording parameters, channels, and groups.
Process for saving recordings onto USB storage.
Best practices and solutions for USB storage issues during recording.
Understanding electrical and GPS trigger signals for lap timing.
Configuration steps and methods for preventing false triggers.
Methods for timing laps and analyzing segment data.
Configuration for comparing current lap times to expected ones.
Steps to set up a recommended GPS sensor for positioning.
Common issues and solutions for GPS sensor operation.
Detailed instructions for updating the device firmware via RaceCon.
Steps to create and apply device configuration clones.
Configuring fuel tracking and tank management.
Monitoring and resetting fuel consumption data.
To Next Page
