SP00D00616 2019-11-08| Robert Bosch GmbH
46 | ACS 663 | Precautionsen
2.2 Protection devices
The station is equipped with the following protection
devices:
High pressure safety valves.
A high pressure switch that stops the compressor
when excessive pressure is detected.
WARNING: Tampering with these
protection devices can cause serious injury.
WARNING: Do not modify the high
pressure safety valve or the main
settings of the system. Using the machine
differently than as it was designed
compromises its functionality and invalid
the protections it is equipped with.
CAUTION: Always check the pressure
gauges readings to check that the
pressures are maintained within the limits
specified in the "Technical Data" section.
2.3 Door interlock switch
The interlock switch on the rear service door
interrupts the power supply of the machine when it is
open.
WARNING: Do not tamper with the
interlock switch in any way. During normal
operation, the rear service door must
always be closed and the overhead panel
installed in position.
2.4 PED directive 2014/68/EU
The machine includes parts subject to PED EU
directive 2014/68/EU, Pressure Equipment Directive.
PED directive regulates all the pressurized part
defining for them categories based on volume-
pressure ratio and based on fluid refrigerant type.
Those parts then have not to be anyhow modified nor
removed. Under the responsibility of the owner, the
machine and parts falling in the scope of PED shall be
checked either during commissioning and periodically
fulfilling local country regulations and norms.
Parts in the scope of PED are:
Tank.
Pressure relieve valve.
High pressure switch.
Recovery group.
Piping.
i Call Bosch service center to get technical specifica-
tions for each part listed.
2.5 ACS 663 handling
The ACS 663 must normally be moved on flat surfaces
with a maximum slope of 15° and on four wheels,
avoiding excessive shaking. When stopped the front
wheels brake must be engaged. On slightly irregular
surfaces, the ACS 663 can be moved, keeping it
slightly inclined and set on the ground on the two rear
wheels making sure to have a firm grip on the rear
handle.
CAUTION: Although the heavier
components of the ACS 663 are installed
on the bottom of the ACS 663 in order
to lower the center of gravity as much as
possible, the risk of overturning is not
completely eliminated.
To Next Page
Loading...
