Need help?Do you have a question about the Bosch WORCESTER GREENSTAR and is the answer not in the manual?
General| Brand | Bosch |
|---|---|
| Model | WORCESTER GREENSTAR |
| Category | Industrial Equipment |
| Language | English |
Defines signal words used for warnings and their meanings.
Provides essential safety notices for installation contractors and users.
Describes the module's intended communication via EMS 2 interface.
States that installation must be done by a competent person and to use genuine spare parts.
Emphasizes electrical work must be done by a qualified electrician and outlines safety precautions.
Instructs on explaining system operation, safety, and maintenance to the user.
Advises on preventing frost damage and keeping the system operational.
Highlights risks like scalding and floor damage with specific warnings.
Details the product's technical specifications, including dimensions and ratings.
Provides instructions on how to clean the module casing.
Guides on fitting accessories according to regulations and supplied instructions.
Describes the process of mounting the module on a wall or mounting rail.
Critical safety warning about electric shock hazards during installation.
Reinforces the critical danger of electric shock from live parts.
Details connecting the BUS and temperature sensor, including cable length and interference avoidance.
Crucial warning about the risk of electric shock from mains voltage.
First step in electrical connection: routing cables through grommets and connecting to plugs.
Second step in electrical connection: re-inserting grommets and plugging in connected cables.
Fourth step: re-inserting grommet and plugging in connected plugs.
Fifth step: securing connected cables with strain relief.
Sixth step: routing cables, removing plugs, connecting, and re-routing.
Eighth step: replacing grommets and plugging in connected plugs.
Final step: fitting the module cover after connections are made.
Guidance on wiring for unvented DHW cylinders, including safety limit thermostat interaction.
Warning against taking feed through control thermostat to safety limit thermostat.
Details on connecting room thermostats or link wires, including jumper use.
Lists components and their connections for the Y-plan system.
Defines the terminals on the module and their functions for the Y-plan system.
Lists components and their connections for the S-plan system.
Defines module terminals and their functions for the S-plan system.
Lists components and their connections for 3 heating circuits.
Defines module terminals and their functions for 3 heating circuits.
Notes on connecting system components with coding 3 for 3 heating circuits.
Lists the necessary Worcester products for this system configuration.
Ensures G3 compliance for unvented DHW cylinders via safety thermostat power supply.
Details the dial settings and hot water temperature adjustment for commissioning.
Explains pairing and setup for Comfort II RF thermostats for zone 1 and zone 2.
Explains priority given to hot water and valve motorisation times.
Step-by-step guide to pairing Comfort II RF devices with the receiver.
Step-by-step guide to unpairing Comfort II RF devices from the receiver.
General commissioning steps: electrical connections, power supply, and system setup.
Explains how Code Switch I sets the system type (Y-plan, S-plan, etc.).
Details the function of Temperature Switch II for DHW temperature and legionella protection.
Outlines the steps for system and module commissioning, including code switches and power-on.
Describes the module's status indicator and its possible causes and remedies.
Provides safety instructions and steps for replacing the module's fuse.
Critical safety warning about electric shock when handling the fuse.
Describes the company's commitment to country-specific recycling for packaging materials.
Guides on the environmentally compatible recycling of old electrical and electronic appliances.
To Next Page