English–16
0 276 001 USAen | (17.6.15) Bosch eBike Systems
Interaction of the eBike System with the Bicycle Gears
The bicycle gears should be used as with a normal bicycle,
even with eBike motor assistance (please follow the operat-
ing instructions for your eBike).
Independent of the type of gearing, it is recommended to
briefly interrupt the pedaling while changing gears. This
makes changing gears easier and reduces the wear on the
drive train.
By selecting the right gear, you can increase the speed and
range with the same pedaling effort.
For this reason, follow the shift recommendations provided
by indications g and h on your display. If indication g is dis-
played, you should shift to a higher gear with lower ca-
dence. If indication h is displayed, you should select a lower
gear with higher cadence.
Test the operating range of your eBike under different con-
ditions before planning longer and more challenging rides.
Read and understand the “Influences on the Operat-
ing Range” section below before planning your ride.
Influences on the Operating Range
The operating range depends on many factors, such as the
following:
– Assistance level,
– Gear-switching behavior,
– Bicycle tires and tire pressure,
– Age and condition of the battery pack,
– Route profile (inclines) and road or path conditions
(road or path surface),
– Headwind and ambient temperature,
– Weight of the eBike, rider and equipment/luggage.
For this reason, it is not possible to precisely predict the
range before or during a trip. General rules:
–For the same motor output of the eBike drive unit: the
less power or force that you have to bring about to reach
a certain speed (e.g., through optimal use of the gears),
the less energy the eBike drive unit will consume, and
the greater the range will be for a battery pack charge.
–The higher the assistance level under otherwise identi-
cal conditions, the shorter the range will be.
Note: Plan your routes so that you can also reach your des-
tination each time without motor assistance.
Transport
If you carry your eBike outside of your car, e.g. on a
luggage rack, remove the on-board computer and
the eBike battery pack in order to avoid damaging
them.
Always remove the battery pack from the bicycle be-
fore transporting the bicycle on a vehicle bike rack.
Failure to remove the battery pack when using a vehicle
bike rack can lead to death or serious injury. The battery
may detach during transport and cause an accident to
following vehicles.
Always use an approved and compatible bicycle rack
when transporting your eBike. The Bosch Drive Sys-
tem adds weight to the bicycle. Refer to your bicycle
rack manual to be sure your eBike is compatible. Over-
loading a bike rack can result in death or serious injury.
Use proper lifting techniques because electric bikes
are generally heavier than bicycles.
Ship batteries only when the housings are undamaged.
Tape or mask off open contacts and pack up the battery in
such a way that it cannot move around in the packaging.
Notify your parcel service that the package contains dan-
gerous goods. Please also follow possibly more detailed
national regulations. Always check the state and federal
regulations before attempting to ship your battery.
In case of questions concerning transport of the battery
packs, please contact an authorized Bosch eBike dealer.
Bosch eBike dealers can also provide suitable transport
packaging.
WARNING
To Next Page
Loading...
Need help?
General
