To Next PageTo Next PageWhat to do if my Bosch AQT 45-14X Pressure Washer motor stops?
If your Bosch Pressure Washer motor stops, consider these possible causes: * A faulty or blown fuse could be the culprit; replace it. * The mains voltage might be incorrect; verify that it matches the specifications on the model tag. * The motor protector may have activated; allow the motor to cool for 15 minutes.
Why does my Bosch AQT 45-14X Pressure Washer motor start but have no pressure?
If your Bosch Pressure Washer motor starts up but provides restricted or no working pressure, consider the following: * Ensure that the water supply is connected. * Clean the water filter if it's clogged. * Clean the nozzle if it's clogged.
What to do if Bosch AQT 45-14X motor starts but there is no pressure?
If your Bosch Pressure Washer motor starts but there's no pressure, the nozzle might be partly blocked. Try cleaning the nozzle.
How to fix a Bosch AQT 45-14X Pressure Washer when the motor refuses to start?
If your Bosch Pressure Washer motor refuses to start, there are several potential causes: * Ensure the plug is properly connected. * Try a different mains socket to rule out a faulty socket. * Check and replace the fuse if it's faulty or blown. * Remove any extension cables to see if they are the issue. * Allow the motor to cool for 15 minutes if the motor protector has activated. * Ensure that pump/water supply hose/accessory is not frozen.
Why does my Bosch AQT 45-14X motor sound like it's starting but won't actually start?
If your Bosch Pressure Washer motor “sounds” but fails to start, check the following: * Ensure that the voltage of the mains power supply line is the same as that on the plate, as insufficient power supply can cause this issue. * If you're using an extension cable, voltage loss might be the problem. Check the characteristics of the extension cable.
Why is water leaking from my Bosch AQT 45-14X?
A slight water leak from your Bosch Pressure Washer is permissible. However, if the leak is excessive, contact a service center.
Why is the pressure pulsating on my Bosch AQT 45-14X and how to fix it?
If your Bosch Pressure Washer experiences pressure pulsation, it could be due to several reasons: * There might be air in the inlet water supply hose or pump. To resolve this, run the pressure washer with the spray handle open and the nozzle at low pressure until regular working pressure is achieved. * The water supply may be inadequate. Ensure it meets the specifications, with a minimum hose diameter of 1/2" or 13 mm. * The water filter could be blocked, requiring cleaning. * Check for and straighten any kinks in the water supply hoses. * If using a high-pressure extension hose, remove it and retry, ensuring it doesn't exceed the maximum length of 7 m.
What causes low but steady pressure in my Bosch AQT 45-14X Pressure Washer?
If your Bosch Pressure Washer experiences low but steady pressure, it could be due to: * A worn nozzle. If this is the case, change the nozzle. * A worn start/stop valve. Try activating the trigger five times in quick succession.
Why do the fuses keep blowing on my Bosch AQT 45-14X?
If the fuses in your Bosch Pressure Washer blow, it might be because they are incorrectly rated. Change to a mains supply higher than the pressure washer amp consumption.
General| Brand | Bosch |
|---|---|
| Model | AQT 45-14X |
| Category | Pressure Washer |
| Language | English |
Details electrical connection, plug safety, cord replacement, and socket requirements.
Covers water supply regulations, hose requirements, and backflow valve necessity.
Covers general use, pre-operation checks, and specific cleaning advice.
Emphasizes safe operation, chemical handling, environmental safety, and PPE.
Outlines user responsibilities, supervision, handling, and weather precautions.
Provides detailed specifications for the pressure washer models.
Step-by-step guide for initial setup and starting the pressure washer.
Addresses problems like motor not starting, stopping, or blowing fuses.
Covers issues with lack of pressure, pulsating pressure, or low pressure.
Guides on troubleshooting self-starting issues and water leaks.
