16 B94x/B93x Actions menu
Use the Actions menu to reset sensors, change outputs, see the
test menu, see the RPS menu, go to an area, update system
firmware, or to view service bypassed points.
16.1 Reset
Detection devices, such as smoke detectors and shock sensors,
might require a reset action before they return to normal
operation. This function momentarily removes power from these
devices to reset them.
Resetting sensors:
1. Open the Main menu.
2. Press [Actions] to open the menu.
3. Press [Reset] to open the menu.
4. Enter your passcode and press [ENTER]. The display shows
Sensors resetting for approximately 3 seconds and then goes
blank before returning to idle disarmed text.
If you enter this function and the detector or sensor resets
momentarily, but then returns to a faulted condition, the
conditions causing the activation may still be present or the
detector may be faulty. Check to be certain that there is no
smoke, fire, or other danger present.
Control Panels B94x/B93x Actions menu | en 71
Bosch Security Systems, Inc. 2015.01 | 02 | F.01U.307.371
To Next Page
Loading...
Need help?
General
